Escort Prism 20401 Especificações descarregar pdf (Página 145)

10-3

NO SENSOR is displayed. Sensor not connected.

Damaged Sensor or cable.

Unknown sensor connected.

Check sensor connections.

Verify red light on sensor

illuminates. Replace cable if

necessary.

Replace with Masimo sensor.

Invasive Blood Pressure Solutions

Problem Possible Causes Action/Solution

Will not zero - ZERO OUT OF

RANGE displays.

Faulty transducer or transducer

not zeroed.

Try new transducer or rezero

current transducer.

Will not zero - NO ZERO:

PULSE DETECT displays.

Monitor has detected a pulse.

Open stopcock on transducer to

air and rezero.

Pressure values lower than

expected.

Dampened waveform from

bubbles in line.

Transducer was repositioned

after zeroing was completed.

Flush line.

Rezero transducer.

Pressure values higher than

expected.

Excessive tubing length causing

resonance.

Reduce tubing length and rezero

transducer.

Noninvasive Blood Pressure Solutions

Problem Possible Causes Action/Solution

CHECK CUFF message.

Poor connection to monitor or

cuff.

Cuff or hose assembly is

leaking.

Cuff is loose on patient.

Verify NIBP assembly is

connected.

Check cuff and hose for leaks.

Make sure cuff is correct size

and snug.

ARTIFACT message. Too much patient movement. Reduce patient movement and

retake reading.

LOW OSCIL message.

Pulse detected too low due to

improper placement or tightness

of cuff.

Make sure cuff is positioned

correctly and snug on patient.

NIBP pump turns on and off

during inflation.

Monitor is set to PED or NEO

mode.

If monitoring an adult patient,

switch to ADULT mode,

otherwise this behavior is

acceptable.

Inaccurate NIBP readings. Improper cuff placement or size. Check proper cuff placement or

size.

MAX 2 LOW message.

Monitor did not obtain valid

systolic reading.

Retry reading. Note:

subsequent inflations are 25

mmHg higher.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 169 170

Comentários a estes Manuais

Sem comentários

Escort Prism 20401 Especificações Página 145

Comentários a estes Manuais